Xpress Tools series are made by Aluminum or Graphite & it is specially designed for professional rc racing car drivers. It includes car set up stand, chassis droop, parts tray, ride height guage, droop gauge & more
Model: XP-40208
Description:Multi function shock repair/service tool which simplifies the process and makes your life easier without having to use multiple different tools to rebuild or build new shocks! Multiple different stepped parts which let you measure different lengths to ensure all four of your shocks are t..
Model: XP-40001
Description:
Introducing the Xpress Car setup stand featuring a carbon fibre top plate and with aluminum side rails! Carbon Fibre was chosen as the top plate as it is less prone to bending when compared to aluminum allowing for a more sturdier car stand. Also has pre drilled holes which allows this ..
Model: XP-40072
Description:Xpress multi functional parts tray, an invaluable tool to keep on your pit table. Besides from neatly organizing screws, this tray has sections which allows you to solder banana plugs and even hold your gear diffs for easy rebuilding!..
Model: XP-40005
Description:1mm Stepped Droop Measuring gauge for 1/10 touring cars. *Photos for reference only. Shown is a complete set of Xpress Touring Car Chassis setup tools, others sold separately...
Model: XP-40004
Description:Measure your droop off the ground with these droop blocks which prevents uneven measurements due to chassis wear and may give you an incorrect reading when measuring off your setup board.*Photos for reference only. Shown is a complete set of Xpress Touring Car Chassis setup tools, others..
Model: XP-40210
Description:Aluminum wrench to make wrenching on your Execute XQ11 easier, locking wrench for holding your spur in place to easily tighten the locking nut. The 6.5mm wrench side is for holding the ball studs under the arms in place...
New
Model: XP-40269
Multifunction turnbuckle tool for easy building and adjusting turnbuckles! In the center is a cutout for sliding in 4mm ball ends to hold them in place during building. A 4mm wrench at the other end for adjusting and a 1.5mm pin to adjust turnbuckles with a adjustment hole!..
Model: XP-40006
Description:0.2mm Stepped Droop Measuring gauge for 1/10 touring cars for a ultra fine measurement for droop. *Photos for reference only. Shown is a complete set of Xpress Touring Car Chassis setup tools, others sold separately...
Model: XP-40007
Description:0.2mm Stepped Ride Height Measuring gauge for 1/10 touring cars for a ultra fine measurement for rideheight. Even number decimals on one side and odd on the other side for you to get the most precise measurement available! *Photos for reference only. Shown is a complete set of Xpress To..
Showing 1 to 9 of 9 (1 Pages)